Rear center - epilog input

Discussion in '3-D Audio' started by Rogacz, Jan 4, 2005.

  1. Rogacz

    Rogacz Porcupine Floyd

    Joined:
    Oct 3, 2003
    Messages:
    421
    Likes Received:
    0
    Trophy Points:
    0
    Which input on epilog routes signal to rear center? (on 6.1 configs), or if there is no input then how it's done?
     
  2. Eugene Gavrilov

    Eugene Gavrilov kX Project Lead Programmer and Coordinator

    Joined:
    Dec 7, 2002
    Messages:
    3,146
    Likes Received:
    9
    Trophy Points:
    48
    "k2 i2s left/right"
    if there's no input, it is silent

    E.
     
  3. Rogacz

    Rogacz Porcupine Floyd

    Joined:
    Oct 3, 2003
    Messages:
    421
    Likes Received:
    0
    Trophy Points:
    0
    But if it's i2s left/right then it should work for left and right too, am I right?
     
  4. Eugene Gavrilov

    Eugene Gavrilov kX Project Lead Programmer and Coordinator

    Joined:
    Dec 7, 2002
    Messages:
    3,146
    Likes Received:
    9
    Trophy Points:
    48
    no :)
    for 6.1 card 'i2s left' is 'rear center', while for 7.1 card i2s left & right are 'back left / back right' -- just try

    E.
     
  5. Rogacz

    Rogacz Porcupine Floyd

    Joined:
    Oct 3, 2003
    Messages:
    421
    Likes Received:
    0
    Trophy Points:
    0
    Ah, now I understand it perfectly. Is there any possibility to change those namings to say, "rC" in the final 3538 release for cards that support 6.1?
     
  6. Eugene Gavrilov

    Eugene Gavrilov kX Project Lead Programmer and Coordinator

    Joined:
    Dec 7, 2002
    Messages:
    3,146
    Likes Received:
    9
    Trophy Points:
    48
    no, since both outputs are shared among different 6.1, 7.1 and 8.1 cards (if any) :)

    E/
     

Share This Page

visited