speaker setup: 2.1 and output

Discussion in 'General Discussion' started by HumanRes, Aug 11, 2003.

  1. HumanRes

    HumanRes New Member

    Joined:
    Mar 6, 2003
    Messages:
    26
    Likes Received:
    0
    Trophy Points:
    0
    I have a sblive value card (4832, 10k1, it's no 5.1 card).

    I selected 2.1 surround on mode in speaker config. I hear all sounds via the headphones-out on my headphones.

    But in this mode, there is no signal on line out, which i normally use to connect the card to my amp. I would like to hear the same output as on my headphones. How do i get this?

    Until today i had 5.1 copy mode selected, so i was able to achive the above questioned setup, but it had the disadvantage that i couldn't hear the rear signals of a surround source. With 5.1 surround on, I hear the front output on my headphones, the rear output on my amp. But i need identical signals on both outputs without sound loss.

    Can someone help here?
     
  2. geraldandreas

    geraldandreas KX-Driver Lover

    Joined:
    Mar 31, 2003
    Messages:
    241
    Likes Received:
    0
    Trophy Points:
    0
    Speaker setup

    hello, i think you have to connect wires in the dsp. i´m not shure, what pins in epilog you have to use but i think it is 8/9 (when you go with the cursor over the connectors, there will be "swapped" written.) regs, gerald
     

Share This Page

visited