Using Prologica from an analogue source...

Discussion in 'Effects and the DSP' started by the.chill, May 26, 2012.

  1. the.chill

    the.chill New Member

    Joined:
    May 23, 2012
    Messages:
    4
    Likes Received:
    0
    Trophy Points:
    0
    Hey, I'm new to kX, so forgive my ignorance, but how do I use Prologica to expand an analogue source from AC97 Line In and output the individual analogue 5.1 channels?

    Could anyone point me to an existing preset that will do the trick?

    Regards.
     
  2. Russ

    Russ Well-Known Member

    Joined:
    Jan 17, 2005
    Messages:
    5,722
    Likes Received:
    13
    Trophy Points:
    48
    Easiest method is to grab (and install) ProFX from here: http://www.hardwareheaven.com/effects-dsp/70261-new-profx-3538-update-incl-mx6-ac97.html

    Save your current DSP config (so that you may reload it later).
    Clear the DSP.

    Load the "ProFX:ADC" plugin.
    Load the "Prologica" plugin.
    Load the "ProFX:kXlt" plugin.

    Open the GUI for ADC and configure the left side (REC SOURCE) of the Window for Line In (and adjust volume as necessary).

    Connect the top 2 pins out of ProFX:ADC to the inputs of Prologica and connect the outputs of Prologica to ProFX:kxlt.

    Open the GUI for kxlt and configure your speakers to match how you connected it from Prologica, etc.

    Note: With this config, there are no controls for speakers volumes, etc (they will be at full volume), so you may want to include some volume plugins (e.g. vol, St Vol, GainHQ, etc) or just adjust the volume in ADC.
     
    Last edited: May 27, 2012

Share This Page

visited